Cwfl-6000 Manual

Up to 14kW to 15kW depending on ambient conditions.

The of your Teyu/S&A CWFL-6000? The brand and power of the fiber laser it is cooling?

The chiller maintains a fixed user-defined temperature regardless of ambient shifts. This mode is preferred in highly climate-controlled facilities. Changing Parameters (e.g., Switching to Constant Mode) To modify settings, you must unlock the controller panel: cwfl-6000 manual

Clean dust filters; check if laser heat generation exceeds 15kW. Ultralow Water Temperature Water temperature dropped below safe operating limit.

Separate cooling circuits for the laser source (low temp) and the optics (high temp) to prevent condensation. Stability: Maintains temperature within ±1∘Cplus or minus 1 raised to the composed with power C . Up to 14kW to 15kW depending on ambient conditions

High-pressure, high-flow industrial pump designed for continuous 24/7 duty cycles. 2. Unboxing and Pre-Installation Setup Environmental Requirements

Check the water level gauge to ensure the fluid remains in the green zone. Winter Maintenance (Anti-Freezing)

The CWFL-6000 features a phase sequence protector. If the chiller power switch is turned on but the unit does not start, you may have reversed two of the phase wires. Disconnect power and swap any two phase lines. Signal Alarm Output

The chiller provides a dry contact relay output (normally open/normally closed options).

The CWFL-6000 includes internal particle filters. Replace the filter elements to maintain high flow rates and clean water clarity. Winter Maintenance (Anti-Freezing)