Fanuc Series Oitf Plus Programming Manual Jun 2026

: Rapid positioning to move tools quickly without cutting.

Built-in algorithms that improve surface finish quality without reducing cutting speeds.

Are you programming for a or a lathe (turning center) ? fanuc series oitf plus programming manual

From the manual’s warnings and experienced users’ notes:

Standard feed mode for lathes (expressed as inches/mm per revolution). 3. Multi-Repetitive Canned Cycles (G70 - G76) : Rapid positioning to move tools quickly without cutting

The G71 cycle removes material in linear steps parallel to the Z-axis (O.D. or I.D. turning). It uses a two-line block format on FANUC systems. G71 U0.1 R0.05 G71 P100 Q200 U0.02 W0.005 F0.012 Use code with caution.

The manual is typically divided into several key sections, progressing from fundamental concepts to complex system configurations. From the manual’s warnings and experienced users’ notes:

The reference point chosen by the programmer (the part origin or "X0, Y0, Z0"). Standard first fixture offset.

G-codes form the core language of the FANUC 0i-TF Plus controller. Turning centers rely heavily on specific preparatory commands to execute precise cuts. Motion Commands