Kincaid Radio Controlled Clock Instruction Manual [updated] -

Locate the time zone buttons on the back of the movement (typically labeled for Pacific, M for Mountain, C for Central, and E for Eastern).

If you intend to store the clock or leave it unused for several months, always remove the batteries to prevent catastrophic chemical leakage and corrosion inside the battery terminal housing.

The hands will rapidly spin forward and stop precisely at the 4:00, 8:00, or 12:00 position. The clock will then pause and enter "Signal Search Mode." It will remain perfectly still for 3 to 10 minutes while it listens for the WWVB tower.

A: 99% of the time, this is a battery issue. Even if the battery is new, it may be drained or have poor contact. Try a different battery brand. kincaid radio controlled clock instruction manual

Use the or DOWN / - buttons to adjust the flashing value.

The hands will begin to move forward. Keep holding the button until the hands closely approach your desired time, then release it.

If your clock is exactly one, two, or three hours off, the atomic signal is working perfectly, but your Time Zone setting is incorrect. Follow the instructions in Section 2 to adjust your zone. Locate the time zone buttons on the back

Follow these step-by-step instructions to initialize your clock for the first time or after a battery change. Step 1: Insert Fresh Batteries Open the battery compartment on the back of the clock.

If your clock is exactly one or more hours off but the minutes are perfectly accurate, the radio receiver is working, but your settings are incorrect.

Kincaid Radio Controlled Clock Instruction Manual: The Complete Setup and Troubleshooting Guide The clock will then pause and enter "Signal Search Mode

The hands (on analog models) may fast-forward to 4, 8, or 12 o'clock and stop while searching for a signal.

, even if the clock is still running. Low voltage can cause the radio receiver to fail long before the display fades or the hands stop moving.

Look for these indicators: