The ...calibration-rescue-244.bin file re-flashes the base station, often specifically addressing the calibration data, allowing the unit to re-initialize and communicate with SteamVR again.
Wait for a few seconds and then release the button. The base station should now appear as a named "CRP_DISABLED" in your File Explorer. 3. Apply the Fix Open the "CRP_DISABLED" drive. Delete the existing firmware.bin file inside.
The file is likely already on your computer if you have SteamVR installed. lighthouse-tx-htc-2-0-calibration-rescue-244.bin
The file lighthouse_tx_htc_2_0-calibration-rescue-244.bin is an official factory emergency recovery firmware package created by Valve and distributed via SteamVR.
This deep-dive technical article explains what this file does, why base station errors happen, and how to safely run the manual calibration rescue procedure to recover your virtual reality tracking setup. What is lighthouse_tx_htc_2_0-calibration-rescue-244.bin ? The file is likely already on your computer
Did this error happen or after a physical drop/power outage? Share public link
Follow these steps carefully to flash the rescue firmware onto your malfunctioning base station. 1. Preparation Unplug the power cable from the wall. Unplug the sync cable (if using one). plug in the power adapter.
Paste the rescue file directly into the empty "CRP DISABLD" drive.
Using a paperclip or a SIM ejector tool, press and .
: While holding the small mode button on the back of the base station, plug in the power adapter. Your PC should recognize it as a removable drive named "CRP DISABLD." Applying the Fix : Open the drive and delete the existing firmware.bin file.