New — Narishige Pc10 Manual

Located at the bottom of the lower slider shaft. Removable ring weights allow users to modify the gravitational pulling force.

It turns out, a quiet community of DIY electrophysiologists, instrument hackers, and vintage lab gear enthusiasts have been creating new guides from scratch. They’re reverse-engineering the calibration steps, recreating the wiring diagrams, and even translating the original Japanese-only schematics into clean, searchable PDFs.

The PC-10 offers two distinct modes depending on your desired pipette geometry. Single-Stage Pulling (For Long, Gradual Tapers)

Ideal for patch-clamp pipettes requiring a rapid taper and a stiff, low-resistance tip. Configure the toggle switch to . narishige pc10 manual new

: Pulling temperatures must be adjusted based on ambient lab temperature and the "age" of the heating filament. 4. Operational Best Practices

Variable weights (sub-weights can be added or removed from the slider).

Thread the glass capillary vertically through the center of the platinum heating coil. Located at the bottom of the lower slider shaft

The front panel of the PC-10 features analog dials and toggle switches designed for precise manual adjustments. Understanding these controls is vital for reproducible results.

Set the Heater No. 1 and Heater No. 2 dials according to your glass type. Note: Always start with lower values and gradually increase them to protect the platinum coil from burning out. Step 5: Execute the Pull

Regular maintenance ensures the longevity of the mechanical sliders and electrical connections. Configure the toggle switch to

Your (e.g., patch-clamp, microinjection, or extracellular recording)

Are you experiencing any specific with your new unit? Share public link