Rc522 Proteus Library -

The RC522 module communicates with the host microcontroller via a standard interface. The key pins are:

#define RST_PIN 9 #define SS_PIN 10

Installing the component is only half the journey. You also need to wire it correctly and configure your simulation environment. rc522 proteus library

Connect the respective SPI pins together: Arduino Pin 13 →right arrow Arduino Pin 12 →right arrow RC522 MISO Arduino Pin 11 →right arrow RC522 MOSI The RC522 module communicates with the host microcontroller

Because you cannot physically swipe a real plastic RFID card against your computer monitor, the Proteus RC522 library uses a clever workaround to simulate tag detection: Serial.println("Place tag near reader...")

void setup() Serial.begin(9600); SPI.begin(); mfrc522.PCD_Init(); Serial.println("Place tag near reader...");

Navigate to your Proteus installation directory. The default paths are: