: The controller detected encoder activity (car drift) while the car was supposed to be idle. Often caused by brake issues or machine slippage. 0013 - OverSpeed
These codes relate to the motor and speed regulation system.
| Blink Count | Error Type | Possible Cause | |-------------|------------|----------------| | 1 | Overcurrent | Short circuit in motor wiring, failed IGBT module | | 2 | Overvoltage | Regenerative power issue, brake resistor failure, mains surge | | 3 | Undervoltage | Low mains supply, blown fuse, DC bus undervoltage | | 4 | Overspeed | Brake slipping, encoder failure, drive parameter mismatch | | 5 | Overtemp | Cooling fan failed, ambient temp too high, overloaded | | 6 | Encoder loss | Loose connection, faulty encoder, broken cable shield | | 7 | Brake feedback | Brake not opening/closing properly, worn contacts or coil | | 8 | Door zone error | Magnet/sensor misalignment, bad door zone switch | schindler 5500 error codes
Meaning: The actual speed reported by the encoder does not match the target speed curve calculated by the drive.
If you want, I can:
On the Schindler 5500, technicians typically access error logs via the interface or the LMS (Lift Management System) tool. You will need the service tool connected to the control box (usually located in the machine room or atop the car).
If multiple communication faults occur simultaneously, check the terminating resistors on the CAN line and inspect for pinched wires running down the traveling cable. Safety and Regulatory Disclaimer : The controller detected encoder activity (car drift)
Schindler SMART 002 LED Error Codes | PDF | Elevator - Scribd
: The absolute shaft positioning system that tracks elevator height using a magnetic tape sensor system. Architectural Overview of Error Codes | Blink Count | Error Type | Possible