Go to the builds page.
Click to browse or drag and drop files
Choose ONE option:
Option 1: BIOS Files - dc_boot.bin (2MB) + dc_flash.bin (128KB)
Option 2: ELF File - Any .elf executable file
If your server is hooked up to a display and keyboard, you can reset the settings without moving the USB drive.
Run the following commands to delete the network settings and network rules: rm network.cfg rm network-rules.cfg Use code with caution. Step 4: Restart the Server
You can apply the changes immediately by restarting the Unraid network management daemon, but rebooting the entire server ensures a completely clean initialization. To reboot, type: reboot Use code with caution. Method 3: Reset Settings Remotely via SSH unraid reset network settings install
Navigate to /config/ on the USB drive. Delete (or rename to *.old ):
Use this method if you have a monitor and keyboard attached to the server or still have SSH access. Access the terminal (locally or via SSH). Run the Delete Command: If your server is hooked up to a
After the reboot, your server will automatically request an IP address from your router's DHCP server. You can check the new IP by typing ip a in the terminal.
If your server is tucked away in a closet and you cannot easily plug a monitor into it, you can reset the network by plugging the Unraid USB boot drive into another computer. Step 1: Power Down the Server Safely To reboot, type: reboot Use code with caution
Resetting your network configuration disables custom bridges (like br0 ). If your Docker containers or Virtual Machines were configured with custom IP addresses on your local network, they will fail to start. Go to Settings > Network Settings , enable bridging, and verify your docker/VM network paths match your new layout.
If your server is connected to a monitor and you want a visual interface without using another computer, you can boot into a temporary local GUI. Restart your server. At the Unraid boot menu, select .
If you want to customize this network setup further, let me know: How many your server has If you need to set up custom VLANs or network bonding If you are planning to use Virtual Machines (VMs)
Because Unraid runs entirely in your system memory (RAM) and loads its configuration from a USB flash drive, fixing this issue is straightforward. You can reset your network configuration using three different methods, depending on whether you have physical access to the server or a backup of your flash drive.