Vw Polo 6n Dashboard Removal Updated _hot_

Gently wiggle the dashboard forward by a few inches. Look behind it with a flashlight to verify that no wiring harnesses, zip ties, or ground straps are still attached.

| Location | Fastener type | Notes | |----------|--------------|-------| | Top left & right (under vents) | T25 | Hidden behind vent grilles | | Under radio slot | 10mm nut | Use deep socket | | Behind glovebox area | T20 | Two screws facing firewall | | Lower driver side (knee bar) | 13mm bolt | Attached to metal support | | Side covers (door jambs) | T20 | One each side behind plastic cap | | Center tunnel (under ashtray) | 10mm bolt | Access after removing ashtray | vw polo 6n dashboard removal updated

You have removed 100% of the screws. The dash should now be resting solely on the studs. Gently wiggle the dashboard forward by a few inches

Lean the cluster forward. Unclip the multi-pin connectors. Set the cluster aside in a safe, upright position. 🔩 Phase 4: Main Dashboard Bolts The dashboard is held by several structural points. The dash should now be resting solely on the studs

With the help of an assistant standing outside the passenger door, gently wiggle the dashboard assembly toward the rear of the car. It should lift up slightly and slide backward off its alignment pins.

On some models, you may need to remove bolts from the engine side (plenum chamber) that secure the dash panel cross-member. Dashboard Extraction

: T20 and T25 are the primary sizes used for VW interior fasteners.